TPMS fits BMW 6 Series 2010 - Tire Pressure Sensors SET
DISCLAIMER: All information is to be used as a reference only. Vehicle information is compiled from available manufacturer sources. The application information presented in this document is accurate to the best of our knowledge and is regularly updated with the latest data available in the marketplace. Due to the vast number of car models and spare parts from numerous vehicle manufacturers the exact application of parts is not always feasible. Damage claims, installation fees or removal fees on the basis of data in this listing will not be considered.
|Sensor Frequency||433 Mhz|
|Replaces OE Part Number||36236781847, 36236771034, 36236779490|
|Relearn Procedure||IMPORTANT: Before following the relearn procedure, please be sure to move the old sensors at least one hundred feet away from the car. Inflate all tires to pressure indicated on tire placard. <P>If equipped with iDrive: 1. Turn ignition to ON position (engine off). 2. Press iDrive controller to use “i” menu. 3. Select SETTINGS, press iDrive controller. 4. Select CAR/TIRES, press iDrive controller. 5. You may need to switch to the top field, select TIRES: RDC, and press iDrive controller. 6. Start engine. 7. Select CONFIRM TIRE PRESSURE, press iDrive controller. 8. Vehicle must be driven to complete relearn.</P><P>If not equipped with iDrive: 1. Start engine. 2. Hold turn signal lever in the up or down position until TPMS telltale and RESET are displayed. 3. Press button at end of turn signal lever. 4. Press and hold button at end of turn signal lever until a check appears after RESET. 5. Vehicle must be driven to complete relearn.</P>|