• Home
  • TPMS
  • TPMS fits Ford® F-250 2008-10 - Tire Pressure Sensor

TPMS fits Ford® F-250 2008-10 - Tire Pressure Sensor

UPC: 9452149
(0) No Reviews yet

DISCLAIMER: All information is to be used as a reference only. Vehicle information is compiled from available manufacturer sources. The application information presented in this document is accurate to the best of our knowledge and is regularly updated with the latest data available in the marketplace. Due to the vast number of car models and spare parts from numerous vehicle manufacturers the exact application of parts is not always feasible. Damage claims, installation fees or removal fees on the basis of data in this listing will not be considered.

TPMS fits Ford® F-250 2008-10 - Tire Pressure Sensor
Sensor Frequency315 MHz
Replaces OE Part Number8C2Z-1A189
Relearn CodesFRD-5
Relearn Procedure<b>IMPORTANT:</b> Before following the relearn procedure, please be sure to move the old sensors at least one hundred feet away from the car.<BR><BR>*Ford TPMS Relearn Tool (or properly formatted TPMS learn tool) is required following rotation, tire replacement, and sensor replacement. This tool is located in the glove box with the owner's manual.<br>1. Inflate all tires to pressure listed on tire placard.<br>2. Turn ignition to OFF position and press and release brake pedal.<br>3. Cycle ignition from OFF to RUN position 3 times, ending in RUN position.<br>4. Press and release brake pedal.<br>5. Turn ignition to OFF position.<br>6. Cycle ignition from OFF to RUN position 3 times, ending in RUN position.<br>7. Horn will sound once and TPMS telltale will blink once train mode is initated. If equipped with message center, it will display TRAIN LF TIRE Place antennae of learn tool on sidewall of LF tire 180 degrees from valve stem to activate sensor. Horn will sound once sensor has been regonized. Repeat step for RF RR and LR tires.<br>8. After training LR tire the message center will display TRAINING MODE COMPLETE. If the vehicle is not equipped with the message center display, successful completion can be verfied by turning ignition to the OFF position and not having the horn sound, if the horn sounds the training procedure must be repeated.

Ratings & Reviews

No reviews available

Be the first to Write a Review